Superlite IT C Universal
TECHNICAL DATA SHEET
Material Composition:
Factors affecting on the gasket Areas of application
Dimensions of standard sheets :
1500 X 4000 mm, 1500 X 2000 mm, 1300 X 3900 mm, 1270 X 1270 mm, 2100 X 3000 mm, 1500 X 3000 mm.
Specification: IS 2712:1998
COMPLIANCE: ASTM:F104 F 112221 E23 M7
Finish : Grey / Grey (other Colour on Customer requirement).
Specified Value
Max. Operating Temperature 550
Max. Operating Pressure 200
Density 1.8 - 2.0
Compressibility 5 - 15
Recovery ≥ 40.0
Tensile Strength ≥21.0
Stress Relaxation (16h, 300°C) DIN 52913 ≥ 26.0
Loss on ignition ≤ 26
ASTM oil no.3 (5h, 150°C)
Thickness increase ≤ 20
Weight increase ≤ 15
ASTM Fuel B (5h, 23°C)
Thickness increase ≤ 15
Weight increase ≤ 15
Water (48h, 23°C)
Weight increase ≤ ϭϬ.Ϭ
Flexibility No Cracks
All information and recommendations given in this brochure are correct to the best of our knowledge. However, in view of the wide varity of
possible installation and operating conditions one cannot draw the final conclusion in all application cases regarding the behaviour in a
gasket joint. Therefore, information can only serve as a guideline.
ASTM F 146
ASTM F 146
Kg/cm²
ASTM F 1315 g/cm³
ASTM F 36 A %
ASTM F 36 A %
ASTM F 152 N/mm²
ASTM F 495 %
°C
SUPERLITE - IT 'C' UNIVERSAL
Chrysotile asbestos fibre, Natural Rubber and NBR.
General properties and applications :
Recommended for refrigerating and motor oils, carburetor fuel mixtures, hydraulic fluids, steam, alkalies and
water/antifreeze and water/anticorrosion mixtures and solvents under high stress conditions.
The suitability of a gasket material for an
application is dependent upon a multiplicity of
factors as shown in the above digram. Max.
temperature and pressure values can not define
the suitability for application. It is always
advisable to consider these factors when
selecting a material for a given application .
This area refer , the gasket material is normally suitable subject to
chemical compatibility.
This area refer, the gasket material may be suitable but a
technical support is recommended.
This area refer, do not install the gasket without technical