Superlite IT 300
TECHNICAL DATA SHEET
Material Composition:
Factors affecting on the gasket
Dimensions of standard sheets :
1500 X 4000 mm, 1500 X 2000 mm, 1300 X 3900 mm, 1270 X 1270 mm, 2100 X 3000 mm, 1500 X 3000 mm.
Specification: IS 2712:1998 Grade: W/1
COMPLIANCE: ASTM:F104 F 112001 M7
Finish : Grey/Graphite , Red, Green.
(other Colour on Customer requirement).
Specified Value Unit
Max. Operating Temperature 550 °C
Max. Operating Pressure 150 bar
Density 1.7 -2.20 g/cm³
Compressibility 6 - 14 %
Recovery ≥ 40.0 %
Tensile Strength ≥ 24.0 N/mm²
Stress Relaxation (16h,300°C) ≥ 23.0 N/mm²
Loss on ignition ≤ 28 %
Weight increase
Water (48h, 23°C) ≤ 10.0 %
Flexibility No Cracks --
DIN 52913
ASTM F 495
ASTM F 146
ASTM F 147 B
All information and recommendations given in this brochure are correct to the best of our knowledge. However, in
view of the wide variety of possible installation and operating conditions one cannot draw the final conclusion in all
application cases regarding the behaviour in a gasket joint. Therefore, information can only serve as a guideline.
ASTM F 152
This area refer , the gasket material is normally suitable
subject to chemical compatibility. The suitability of a gasket material for an
application is dependent upon a multiplicity of
factors as shown in the above digram. Max.
temperature and pressure values can not define the
suitability for application. It is always advisable to
consider these factors when selecting a material for
a given application .
This area refer, the gasket material may be suitable but a technical
support is recommended.
This area refer, do not install the gasket without technical
evaluation.
Standard sheet sizes :1500 X 1500 mm,1500 X 2250mm, 1500 X 4500 mm ,1500 X 1000 mm,1000X1000