Superlite Extra
TECHNICAL DATA SHEET
Material Composition:
Factors affecting on the gasket Areas of application
Dimensions of standard sheets :
1500 X 4000 mm, 1500 X 2000 mm, 1300 X 3900 mm, 1270 X 1270 mm, 2100 X 3000 mm, 1500 X 3000 mm.
Finish : Grey/Griphite ,(other Colour on Customer requirement).
ASTM:F104 F 112001 M6
Specified Value Unit
Max. Operating Temperature 460 °C
Max. Operating Pressure 80
Density 1.7 -2.20 g/cm³
Compressibility 6 - 14 %
Recovery ≥ 40.0 %
Tensile Strength ASTM F 152 ≥ 12.80 N/mm²
Stress Relaxation (16h, 300°C) ≥ 17.50 N/mm²
Loss on ignition ≤ 28 %
Weight increase
Water (48h, 23°C) ≤ 10.0 %
Flexibility No Cracks --
All information and recommendations given in this brochure are correct to the best of our knowledge. However, in view of the wide
variety of possible installation and operating conditions one cannot draw the final conclusion in all application cases regarding the
behaviour in a gasket joint. Therefore, information can only serve as a guideline.
Technical data
The following information applies to material thickness 1.5 mm .
Test method
bar
ASTM F 1315
ASTM F 36 A
ASTM F 36 A
DIN 52913
ASTM F 495
ASTM F 146
ASTM F 147 B
Specification
COMPLIANCE:
IS 2712:1998 Grade ,W/2
SUPERLITE - EXTRA
Chrysotile asbestos fibre, Mineral Fibre, Natural Rubber and NBR.
General properties and applications :
To seal off wet steam, water, gases, alkaline chemicals and also suitable for oils & fuels under medium service conditions.
The suitability of a gasket material for an
application is dependent upon a multiplicity of
factors as shown in the above digram. Max.
temperature and pressure values can not define
the suitability for application. It is always
advisable to consider these factors when
selecting a material for a given application .
This area refer , the gasket material is normally suitable subject to
chemical compatibility.
This area refer, the gasket material may be suitable but a technical
support is recommended.
This area refer, do not install the gasket without technical
evaluation.
Standard sheet sizes :1500 X 1500 mm,1500 X 2250mm, 1500 X 4500 mm ,1500 X 1000 mm,1000X1000 mm