Superlite CS
Dimensions of standard sheets :
1500 X 4000 mm, 1500 X 2000 mm, 1300 X 3900 mm, 1270 X 1270 mm, 2100 X 3000 mm, 1500 X 3000 mm.
Thickness: 0.25mm to 6.00 mm
Specification: IS 2712:1998
COMPLIANCE: ASTM:F104 F 112541 E39 M7
Finish : Yellow /Yellow (other Colour on Customer requirement).
Specified Value Unit
Max. Operating Temperature 500 °C
Max. Operating Pressure 100 Kg/cm²
Density 1.8 -2.00 g/cm³
Compressibility 7 - 17 %
Recovery ≥ 40.0 %
Tensile Strength ≥ 21.0 N/mm²
Stress Relaxation (16h, 300°C) DIN 52913 ≤ 30
Loss on ignition ≤ 28 %
ASTM oil no.3 (5h, 150°C) %
Thickness increase 20-40 %
Weight increase 15-30 %
ASTM Fuel B (5h, 23°C) -
Thickness increase 20-40 %
Weight increase 10-20 %
Water (48h, 23°C)
Weight increase ≤ 10.0 %
Flexibility ASTM F 147 B No Cracks ==
All information and recommendations given in this brochure are correct to the best of our knowledge. However, in view of the
wide variety of possible installation and operating conditions one cannot draw the final conclusion in all application cases
regarding the behaviour in a gasket joint. Therefore, information can only serve as a guideline.
ASTM F 36 A
ASTM F 152
ASTM F 495
ASTM F 146
ASTM F 146
ASTM F 146
ASTM F 36 A
SUPERLITE 'CS'
TECHNICAL DATA SHEET
Chrysotile asbestos fibre, Styrene Butadiene Rubber & NBR
It is idealy suitable for joits with low sealing loads & relatively uneven sealing surfaces such as oil pans, valve covers, etc.
Characterized controlled swelling in oils.
The suitability of a gasket material for an application
is dependent upon a multiplicity of factors as shown
in the above digram. Max. temperature and pressure
values can not define the suitability for application. It
is always advisable to consider these factors when
selecting a material for a given application .
This area refer , the gasket material is normally suitable subject
to chemical compatibility.
This area refer, the gasket material may be suitable but a
technical support is recommended.
This area refer, do not install the gasket without technical
evaluation.
Standard sheet sizes :1500 X 1500 mm, 1500 X 2250 mm, 1500 X 4500 mm ,1500 X 1000 mm,1000X1000 mm